(713) 466-6414 M - F 8:30 am - 5:30 pm CST
EP-4086-000 CTS 500K Sealed Premium Audio Pot

EP-4086-000 CTS 500K Sealed Premium Audio Pot

Your Price: $12.50


In Stock
Product Code:EP-4086-000

WARNING: This product may contain a chemical known to the state of California to cause cancer, or birth defects or other reproductive harm. For more information visit www.p65warnings.ca.gov.

500K CTS sealed 282 premium pot with 10% tolerance, special Allparts audio taper, split shaft, with hardware. Lifetime warranty.
5 Stars
Great pot, grounding is done with shild tails
Take the Apllarts shielded cable(s) and cut a bit long. Take a soldering tool with a sharp point and use it like a mini Marlinspike. Make a hole carefully 1/2'' back from the end without tearing any strands. Hook the center conductors and yank those through the hole. If you are jumpering to a tone pot or selector switch use shielded cable prepared the same way. Your shield tails will still be braided with no wild strands to short out. Solder the shields together like a ground bus and tag you ground to the shields. Easy! Or you can buy bare solid wire to use as a ground bus. Try to avoid too many if any loops in the ground. Some plastic pots and switches have a metal crimp tab on the side that is grounded to the shaft and bushing. You can use that too. These are great, last long and don''t get scratchy. Watch how much heat you use carefully! ENJOY!
Did you find this helpful?  6 of 7 Found Helpful
Reviewed by:  from Phoenix, AZ United States. on 8/8/2012 8:34:00 PM
5 Stars
Yep, they do make some great POTs but this sealed one with plastic, DOES it have a bottom thats the metal of the POT? If not just where should someone solder a ground or other connection to the Actual POT that doesnt connect to one of the three?
Did you find this helpful?  3 of 6 Found Helpful
Reviewed by:  from Arlington, TX United States. on 12/10/2011 5:30:00 PM

Related Products

Recently Viewed Products